Polo 6R by RekinPoznan

[ciclo]

From 0:30 to 0:38 sec.



The rest is explained in the diagram (diode).

[ciclo]

Hello

Lookong ....

[RekinPoznan]

Hi

Lookong hehehe sory for errors....

Thanks for fast answer so make now wire , looking for BCM , stalks are buyed , mirror with camera are installed .


Best regards Chriss

[ciclo]

Lookong hehehe sory for errors....

I thought you meant LOL KONG. Yes, "o" and "i" are near on the keyboard.

[RekinPoznan]

Tooday stalks received , preparing to install






7E0937090B are good for HBA , and new type of MFSW from 6C ?

Best regards Chriss

[ciclo]

Yes. (both)

BCM adaptation channel 54 , from 0 to 1, to make work the highbeam stalk with return spring.

[RekinPoznan]

Thanks one day I must make toogether MFSW , HBA and replace BCM.

[RekinPoznan]

Hi friends

Preparing to replace ABS8.2 to ESP9.0i

I looking for coding ESP9.0 for 6R0 907 379AS H03 SW03 i try with this program on screen but no sure the coding is realy correct ?



second question what brake pipe is recomended for my polois i see on ETKA many types.... 6R1614739G and 6R1614740G ??



And for this ESP Unit i have 6R1 614 235 D

Many thanks for help

[iichel]

I'll help out with the coding of ESP9.0i, no problem.

[RekinPoznan]

Thanks IIchel , What do you think of coding from the screen, there are my data entered there is correct ?

[iichel]

looks to be OK but you cannot be sure until you try it the ESP calculator is for sure a great program.

[RekinPoznan]

What can coding be rejected or does ESP not work properly?

[iichel]

yes, coding can be rejected, especially for the ABS. all the parameters need to be correct (brand, type, VIN, engine type). and then it's sometimes still a little puzzle.

[RekinPoznan]

Hi

When change BCM from 7H0937090 to 7E0937090B is recomended copy and paste long codnig , or must be step by step coded ?


Best regards Chriss

[RekinPoznan]

Hi

Why after change BCM I have active adress: 61 ? with 7E0 907 534 , in gateway list is not marked.


Many thanks Chriss