ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

A section of the forum for members to show off their non-polo vehicles.
Post Reply
User avatar
iichel
Bling Bling Diamond Member
Posts: 4092
Joined: Fri Nov 14, 2014 2:14 pm
Drives: Polo 6R 1.2 TDI
Location: The Netherlands

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by iichel »

I sat in the new Golf 8 and I had to say, it took me a while to get used to the new steering wheel.
But anything you have to get used to is not pleasant at first, that's a bit of human nature I guess.
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

... now I'm more intrigued about the new steering wheel model until the T-Cross is delivered ... great! :lol:
Thank you both for your comments!
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 washer jet heater elements

Image

Image



VCDS
BCM
SA
Adaptation

IDE04927-ENG246996-Window heater-WAH_Temp_Wischer_aktiv,-2.0 °C,11
IDE04927-ENG141962-Window heater-Waschduesenheizung,not installed ,11 ...to installed :-)



---
User avatar
iichel
Bling Bling Diamond Member
Posts: 4092
Joined: Fri Nov 14, 2014 2:14 pm
Drives: Polo 6R 1.2 TDI
Location: The Netherlands

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by iichel »

I am slowly getting the feeling you bought a moderately equipped car, on purpose, just for the fun of making it a very richly equipped car ;) Just like you did to your Polo 6R

PS, did you use canbus wiring for this? :mrgreen:
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Well, it's not exactly like that, but something similar ... you know. :wink:
I assure you that we were already very lucky buying this Golf, due to the manufacturing date 08/2018, the units level installed from factory, and the DKRF engine. 8)


The wiring for the washer jet heater elements came with the set from Aliexpress. Everything is correct except the wiring.
I had to modify it due to mismatch of wire colors, the orange/green wire (PIN 1) was dedicated to ground and the orange/brown (PIN2) was dedicated to BCM signal, I cut the end terminals and crimp a new MQS to the orange/green wire.👌
I'll crimp the ground terminal when I determine the exact length of the wire to the ground point...

I also improved the cloth tape :lol: ...because I have a Coroplast tape that is great for outdoors (and expensive). Excellent bonding, insulation and thermal resistance.
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

My intention is to make all the improvements in one go, so that I don't have to disassemble/remove the panels, bumpers and other parts a million times ... :lol:
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 From Park aid (PDC 8K) to Park assist steering (PLA 3.0 12K).

1st
With PDC 8K I think our Golf has the ABS bi-directional sensors on the rear axle from the factory.

-Braking function during maneuver.
Image

I bought the sensors WHT003864B, but I'll have to check it with VCDS before installing them.


https://docs.google.com/spreadsheets/d/ ... 1122661309 8) (My ABS Byte26 = F0 8))
https://forums.ross-tech.com/showthread ... post185693 👌

Front Bumper (full wiring)
Image

Interior
Image
+ two added wires in the 'Lane Change' harness for PLA rear sensors.

Rear Bumper (full wiring)
Image

Supports, original tool for holes, the 4 new sensors.
Image

Super polyurethane glues :lol: and paint (LC9A - pure white) for the supports.
Image

Image

Image

Image

Image




---
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 Heated seats.

Image

Image

Image

Image

Image

Image


BCM change. ...what I explained some previous post.

Climatronic unit change. VCDS process.
-Coding. Check adaptations.
-Basic Setting. Adapt flap end stops.
-AC Compressor First Run-In.


---

https://youtu.be/KWMaXtswEcM?t=137

User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 USB Hub/2nd USB port + 2 rear USB port to charge.

Image
Yes, I have two USB HUBs. :)
Image Image :lol:

Image

Image

Clarifications on PIN 4 vs5v (a clearer diagram ☺) The right way. ✅ 🎹
Image

---

Image
Note:
Image



---
:)
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 Fusebox

Image

Image

Image


Image
Image
Image
Image
Image
Image



---

More wood...
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5. Right front drawer. Manual seat. (LHD/RHD)

Image

Image



---
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

VCDS How to restore all adaptation channels of a module-unit.

:arrow: https://www.ross-tech.com/vcds/tour/con ... ls-map.php

Image

Image

Image

Image


Appearance of the generated file:
-Go to the Logs folder of the VCDS program.
-Open the adphex file with the appropriate program.
-When generating a file with Raw Hex, the values ​​are indicated in Hexadecimal.
Image

In case you want to restore all the adaptations of a module, transfer this file to the desktop,
it will be requested when you select 'Restore adaptations' + 'Raw Hex' + 'Go'.




---


Image
🤣
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Golf 7.5 From IC with black and white display (factory) to IC with color display.

Image

Image

It would be a shame if the IC seen in the image above ended up in the trash with only 700 km. :)

Image
Ready2Go... :lol:



The Active Info Display at another time ... who knows.




---
User avatar
ciclo
Bling Bling Diamond Member
Posts: 5993
Joined: Sun Feb 24, 2013 10:20 am
Drives: 6R Rline/G7.5/Touareg Rline'19/T-Cr'20
Location: Earth ♥, Spain ☼
Contact:

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by ciclo »

Painted PLA sensor supports.

- 4 thin layers of paint, 10-15 m between layers.
Image

- 3 thin layers of glossy varnish, 10-15 m between layers.
Image

8)

Use a mask with a level of protection for workshops as a personal protection measure. Acrylic varnish is highly toxic.🤪
exantas
Bronze Member
Posts: 141
Joined: Sun Jan 06, 2019 5:14 pm
Drives: Skoda Fabia 5J 1.2 TSI
Location: Iceland / Greece

Re: ciclo. Wife's Golf MK7.5 Ready2Go 1.0 TSI 6MT 200Nm/l 115HP

Post by exantas »

Do the Golf bumpers have indications on where to drill for the PLA sensors, or you have to make them on your own?

Sent from my Mi Note 10 Pro using Tapatalk

Post Reply