The g85 resolved. But I have an error in vcds for cruise control. Pin 69 in ecu as you said ciclo but there is no light for on the mfd when I drive over 40 km/h.ciclo wrote: ↑Thu Apr 04, 2024 3:45 am I don't think the fault detected is related to the 'new' BCM/GW (09/19 Addresses), I think it is 99% due to the Basic Setting of the G85 slip ring in the ABS unit (03 Address).
Maybe you are not doing it correctly, have you started the engine to do the Basic Setting?
For the 6R Europe 2009-2014, the G85 basic setting is done in Address 03: ABS Brakes and not in Address 44: Steering Assist.
You would have saved a lot of time (which is more valuable than money), problems, and money, if you had followed my advice and already had the Original diagnostic tool.
Vcds
1 fault found. 6118-cruise control switch (e45) P 0568 00 [037] implausible signal
The stalk was used in another car.
What can it be? Also I bought wires on a german web site with instructions. I would share them here but I do not know how so you can see what pins I used. Strange thing that they said in the instructions ( and wire had that option like a spliter ) was to connect new wire with an existing one and the other end to a pin on the bcm. So I did not connect anything to the fuse box.
What can be an error?