as you know, I have installed the automatic light switch and the automatic wipers in the car. (the well-known RLS).
I notice that the lights come on well before dusk and I wonder if there is any adjustment for the sensitivity of the automatic light system.
for example, I see in the list of adaptations of 09 (BCM) the following lines.
Code: Select all
ENG122926-RLS_wiper_position_parking,15 s,1
ENG122927-RLS_close_glazing,2.0 s,1
ENG122928-ENG121634-RLS_lights_for_autobahn-p_v_autobahn_on,140 km/h,3
ENG122928-ENG121635-RLS_lights_for_autobahn-p_v_autobahn_off,65 km/h,3
ENG122928-ENG121636-RLS_lights_for_autobahn-p_t_autobahn_delay_on,9 s,3
ENG122928-ENG121637-RLS_lights_for_autobahn-p_t_autobahn_delay_off,120 s,3
ENG122929-RLS_LIN_Communication,4 s,1
ENG122930-RLS_tunel_gateway_recognize,5 s,1
ENG122931-ENG123002-RLS_Lights_on_at_Rain-p_n_regenlichtschwelle_high,12 s,2
ENG122931-ENG123003-RLS_Lights_on_at_Rain-p_n_regenlichtschwelle_low,6 ,2
ENG122931-ENG123004-RLS_Lights_on_at_Rain-p_lx_regenlichtschwelle,6000 lx,2
ENG122931-ENG123005-RLS_Lights_on_at_Rain-p_t_regenlicht,30 s,2
ENG122932-ENG123006-RLS_Night_Sensitivity-p_lx_rs_day,500 lx,1
ENG122932-ENG123007-RLS_Night_Sensitivity-p_lx_rs_dawn,200 lx,1
ENG122933-error_mask,Conditions not correct or request sequence error,2
ENG122934-erase_error_table,Conditions not correct or request sequence error,2
ENG122935-RLS_Washer_Front,15 s,1
ENG122932-ENG123007-RLS_Night_Sensitivity-p_lx_rs_dawn,200 lx,1
It may have something to do with the sensitivity of turning on the lights at night.
Does anyone know anything about this?


