induction

tempo · Post by **tempo** » Wed Oct 27, 2004 4:29 pm

I just bought a K&N induction kit but now its all put on theres a big hole where the air filter box used to be I was wondering if anyone new of a surround I could buy to put around it so the K&N doesn't look so out of place?

Speedlaw · Post by **Speedlaw** » Wed Oct 27, 2004 9:51 pm

I know what you're after, but I haven't seen something like that yet. Your best bet is going the DIY route...

tempo · Post by **tempo** » Thu Oct 28, 2004 4:56 pm

was thinking about finding a heat shield or something so the heat from the engine doesn't get to the filter (if it does) but then i dont know where to get one of them from either!!!!