UK-POLOS.NET - THE VW Polo Forum

patil wrote: Sat Jan 23, 2021 3:28 pm

Mocro wrote: Sat Jan 23, 2021 12:01 am
I checked the camera @ vw specalist and they told me the camera is dead.

The usual suspect, that's why I was telling you to test the output of T12/6 &12 to check if camera is working.

Anyway, thanks for informing us.

To find the +30 signal in fuse box, visually inspect the fuse box for presence of terminal inside any of empty fuse slots. If you find any then use multimeter or 12v tester to find out the type of signal present.

Thanks.

iichel wrote: Sat Jan 23, 2021 4:41 pm Can I just say that I'm a bit shocked by the way you're running this red wire to a fuse. Come on man, you're better than this

Mocro wrote: Mon Jan 04, 2021 5:02 pm

Damon wrote: Sun Dec 27, 2020 5:42 pm Okay got it working at front of car.

However I’ve put the bracket with the camera in the registration light but how do feed the cable off the camera into the boot from the bracket?

I push the cable through but can’t seee where it’s coming out?

Remove this
You will see a round rubber thing with wiring remove the rubber
Put a cable in the license plate light holder

You will see the cable is coming to the rubber whole, its little bit difficult but the cable is coming to the rubber whole
43243224.png

Damon wrote: Sat Jan 30, 2021 9:28 am

Mocro wrote: Mon Jan 04, 2021 5:02 pm

Damon wrote: Sun Dec 27, 2020 5:42 pm Okay got it working at front of car.

However I’ve put the bracket with the camera in the registration light but how do feed the cable off the camera into the boot from the bracket?

I push the cable through but can’t seee where it’s coming out?

Remove this
You will see a round rubber thing with wiring remove the rubber
Put a cable in the license plate light holder

You will see the cable is coming to the rubber whole, its little bit difficult but the cable is coming to the rubber whole
43243224.png

Yeah I managed to feed it through.
I just need to make small hole to feed the cable through the rubber at the moment I’ve just got it hanging out.

So what’s your current issue so I understand
Do you see a video image then it goes off? Or not at all?

Mine did that it could come on once then go off, didn’t show lines but camera showed. Had to restart car to get camera to work again for a few seconds.

For me it was because I hadn’t connected the camera can cables for the existing can once done it wokeee fine.

Mocro wrote: Fri Feb 26, 2021 9:38 pm I install OEM golf 7 camera logo on my polo without any issues thanks everybody for the previous problem

Mocro wrote: Sun Feb 28, 2021 8:50 pm Yes i soldering it on the quadlock +30.