Page 1 of 1
throttle body size???
Posted: Wed Jan 28, 2009 10:55 pm
by BIG4244
Hi, just a quick one, what size 90degree bend would i need, i think its a 70mm inside diameter? cheers
Re: throttle body size???
Posted: Wed Jan 28, 2009 10:56 pm
by Tim_GTi
Throttle body size is 63mm
Re: throttle body size???
Posted: Wed Jan 28, 2009 10:58 pm
by BIG4244
ah right so i need 63mm i.d. pipe work, cheers
Re: throttle body size???
Posted: Wed Jan 28, 2009 11:01 pm
by Tim_GTi
Ideally yeh, 64mm will fit though, apparently this can be bought on eBay. I would imagine you'd be able to go up to close of 70mm. Just make sure you secure it tightly with a jubilee clip.
Re: throttle body size???
Posted: Wed Jan 28, 2009 11:04 pm
by BIG4244
nice one, cheers for the help
Re: throttle body size???
Posted: Thu Jan 29, 2009 12:14 am
by Rossco
The bend that holds my CDA is 60mm to the throttle body, it fits, but its a tight fit!
Re: throttle body size???
Posted: Thu Jan 29, 2009 3:37 pm
by Tigz
Cheapest place for a 90º bend?
Im knocking up a cheap K&N kit from bits from my old Renault.
Re: throttle body size???
Posted: Fri Jan 30, 2009 10:21 am
by Tim_GTi
Tigz wrote:Cheapest place for a 90º bend?
Im knocking up a cheap K&N kit from bits from my old Renault.
I would say eBay mate