Page 1 of 2
BMC DIA INDUCTION KIT
Posted: Wed Jun 22, 2011 5:41 pm
by matt_123
BMC DIA 85-150, like the CDA but plastic rather than carbon, and has exactly the same filter and technologies inside. comes with a silicone elbow (got seperate) and fitting bracket with few screws.
£100
Re: BMC DIA INDUCTION KIT
Posted: Thu Jun 23, 2011 3:04 pm
by matt_123
uppp
Re: BMC DIA INDUCTION KIT
Posted: Thu Jun 23, 2011 5:57 pm
by M54 SINGH
picccyss please

Re: BMC DIA INDUCTION KIT
Posted: Thu Jun 23, 2011 7:17 pm
by matt_123
only one ive got mate !
Re: BMC DIA INDUCTION KIT
Posted: Thu Jun 23, 2011 10:08 pm
by M54 SINGH
how good isit?
in regards to throttle response and sound wise aswell?
Re: BMC DIA INDUCTION KIT
Posted: Thu Jun 23, 2011 11:15 pm
by matt_123
mate ive had both the cda and the dia bmc induction kits and cant telll the difference in either, both awsome at noise at high rpm's and nice growl under load at going up through the rev range ive got a straight through exhaust still with cat in and can hear it singing over the exhaust note! - throttle response is greatly improved over standard air box..

Re: BMC DIA INDUCTION KIT
Posted: Fri Jun 24, 2011 6:40 pm
by M54 SINGH
where abouts are you mate?
Re: BMC DIA INDUCTION KIT
Posted: Fri Jul 01, 2011 5:27 pm
by matt_123
BUMP for a decent induction kit
Re: BMC DIA INDUCTION KIT
Posted: Thu Jul 07, 2011 9:23 am
by matt_123
UPP! £100 posted
Re: BMC DIA INDUCTION KIT
Posted: Mon Jul 11, 2011 10:22 am
by matt_123
£100 posted..
BUMP new week
Re: BMC DIA INDUCTION KIT
Posted: Fri Jul 15, 2011 9:16 am
by matt_123
BUMPITY! BUMP!
BMC DIA INDUCTION KIT
Posted: Fri Jul 15, 2011 10:22 am
by benmkiv
Know of this will fit the 1.0 polo 6n2?
Re: BMC DIA INDUCTION KIT
Posted: Fri Jul 15, 2011 3:08 pm
by matt_123
yes mate it will with a reducer

BMC DIA INDUCTION KIT
Posted: Fri Jul 15, 2011 5:40 pm
by benmkiv
Tempting lemme check thhe bank and look for a reducer

Re: BMC DIA INDUCTION KIT
Posted: Fri Jul 15, 2011 9:42 pm
by matt_123
ok mate sure thing