Slammed My 9n Now I Have Problems

[aza_028]

I have slammed my 9n polo today

Changed the droplinks from standard ones to Ford Mondeo 2003 ones however now when i drive and brake the right hand side of the anti roll bar is scraping on the driveshaft

By changing the droplinks from standard to mondeo 2003 ones it is meant to solve this?

There is 1 and 1/2cm left of thread with the helpers out

What would be reccomended? change the droplinks? change the arb?

Answers ASAP please

Thanks

[chewy]

shorter droplinks trey the vmaxx ones they are tiny

[aza_028]

Theres a droplink guide in the 9n3 section which is where it says use 2003 mondeo ones and there fine

thinking about it now the mondeo ones are only around 1inch shorter then the polo ones, is this why i have the rubbing?

[chewy]

Theres a droplink guide in the 9n3 section which is where it says use 2003 mondeo ones and there fine

thinking about it now the mondeo ones are only around 1inch shorter then the polo ones, is this why i have the rubbing?

What coilovers have you got?

As you only have 15mm left on the thread I suspect that your just too low for even the mondeo droplinks

[aza_028]

FK Highsports mate

[chewy]

So your roughly 85mm lower, all it will be is the mondeo droplinks are to long

Try these

http://www.dpmperformance.co.uk/vmaxx-s ... -2513.html

[aza_028]

Will have to get these once get some cash, mondeo ones set me back £20 and thats down the drain now lol, cheers 4 that mate.