Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Check in Long coding if it's enabled. - Maybe there is an wire-ing connections and someone disabled the option so it doesnt pop a dtc fault.
I think under adaptations you can set the timer for how long the defrost function is going to be ON.
amer6R wrote: Tue Feb 28, 2023 12:57 pm
Check in Long coding if it's enabled. - Maybe there is an wire-ing connections and someone disabled the option so it doesnt pop a dtc fault.
I think under adaptations you can set the timer for how long the defrost function is going to be ON.
I’m at a loss, I’ve checked the loom to the tailgate and it’s fine, no broken wires. Changed the fuses again just in case and still nothing. It’s all very strange
Hmm,
I'm not sure. If there is a fuse for the BCM on the fuse holder that is on battery.
What do you think about disassembling the fuse box on battery 10 mm nuts an clean it very well ( sandpaper or wire wheel). Also clean the contact on the small fuse box ( its sits clipped) I had an issue no-communication to module because it was a bit dirty ( high resistance)
Mine is the gti version so the battery is located in the boot, there are some electronics in the engine bay and also some (I think) attached to the side of the battery. Not 100% sure.
I was just reading an old thread regarding the heating of the mirrors, could it be a combination of bit 2 and 3 in the long coding as to why mine arent working do you think?
Do a full autoscan and save it.
Also save long coding from you BCM. ( So you have double backup).
Then edit those two bits. If it doesnt help you can always revert to old settings.
Yeah you will still have fuses under the bonnet as far as i know.