PQ25 R242 3Q0980654P (UP!, etc)

[ciclo]

I totally agree with you 100%, but once you've enjoyed the lane assist with the 2Q0 camera and ALG active, the lane assist with the 3Q0 camera seems like a weak assist to me, and in my humble opinion even dangerous if you're confident or optimistic.
When we evolve to teleportation to move from A to B, with the first teleportation units we'll appear on the other side half human half fly. It's not bad either.

[MrCollayder]

My last experience with 3q0 camera was M sw + modified parameters 600sec from audi q3 8u. It was impressive, because ping-pong effect was at the minimal level. 10 min's of fully hands - and - legs - free with no any indications of lane. Only ACC indication.
And since my car is currently going through a second swap (cwva + 5mt -> cave + dq200 -> cczb + dq250 awd), I decided to get rid of the problem of the lack of lane assist indication too radically))) move polo to pq35

[ciclo]

Thank you very much for the information provided.
It is necessary to have extensive knowledge of both platforms, I wish you the best of luck and success with the progress of your POLO PQ35 project... trully exciting!

[til3tsio]

I couldn't get the P camera to work. No faults, but also no work. Can-combi, A5 activated in the GW, dashboard with lane assist indicator, but nothing. There are 0 lanes recognized by the camera. My bcm is 7e0937090e_0772 from the factory. I've flashed it into 1s0937090m_0780, but nothing.

2 points to think about:
1. Need to check 1s0937090m bcm from the factory, not flashed. Guess, that it has rather different eeprom. Why? Because lane assist button uses the same pin that headlight washer. My flashed 1s0 bcm didn't react to the button, but headlight washer works. Eeprom? 99.9%
2. Dashboard. Up's dash has only indicator. Neither lane assist menus nor pictures. So it seems to me that pq25 sw (polo, amarok, T6) of vdo dash have locked lane assist indications. I'm noy sure, but it really seems to me. Of course, eeprom was corrected, but nothing.
Also dash from UP has an interesting adaptation "Lane assisnt active, yes/no", but no one vdo dash has it. Eeprom again? I doubt it very much.
But there is a good news:
Can powertrain + non-pq25 coding (pq35) makes the camera to work. Yes, there will be a fault in the GW "A5 lost connection" but lane assist will work. Also there won't be any indication on the dash. Because of GW fault.
More detailed (use google translate): https://www.drive2.ru/l/661630848210070242/

Video with 3q0...H_0272 camera https://youtu.be/GlHgts7l-Zg?si=qpWarFjLFSTWFGvx

VCP has a build in BCM PQ25 Parameters editor, I could try but you need to point me to the 1s0 software.

[MrCollayder]

Enjoy it
1S0937090M_0780

[MrCollayder]

Thank you very much for the information provided.
It is necessary to have extensive knowledge of both platforms, I wish you the best of luck and success with the progress of your POLO PQ35 project... trully exciting!

Thank you =))

[til3tsio]

Thanks for sharing and good luck with your conversion project.

[sejuani]

I’ve recently been researching the A5 camera as well.
On a Chinese forum, I found a post about a PQ25 Jetta 1.6 where someone mentioned successfully replacing the A5 camera with a 3Q0 980 654C unit.
I’m currently contacting that person to ask for more details.

https://club.autohome.com.cn/bbs/thread ... 462-1.html

螢幕擷取畫面 2025-10-09 234919.png (126.56 KiB) Viewed 5491 times

[sejuani]

I’ve recently been researching the A5 camera as well.
On a Chinese forum, I found a post about a PQ25 Jetta 1.6 where someone mentioned successfully replacing the A5 camera with a 3Q0 980 654C unit.
I’m currently contacting that person to ask for more details.

https://club.autohome.com.cn/bbs/thread ... 462-1.html
螢幕擷取畫面 2025-10-09 234919.png

The Chinese car owner reported that he is unable to provide more detailed information about the A5 camera retrofit, as the Lane Assist. was installed by a modification shop.
He also mentioned that after consulting with others in China who have experience with similar retrofits, so far no one has been able to make the instrument cluster display Lane Assist–related information.

[Shadow109]

3Q0980654P Camera is fully working on my T5.2 transporter, But also still also nothing appears on the dashboard, I think pq25 clusters don’t support lane assist

[MrCollayder]

I’ve recently been researching the A5 camera as well.
On a Chinese forum, I found a post about a PQ25 Jetta 1.6 where someone mentioned successfully replacing the A5 camera with a 3Q0 980 654C unit.
I’m currently contacting that person to ask for more details.

https://club.autohome.com.cn/bbs/thread ... 462-1.html
螢幕擷取畫面 2025-10-09 234919.png

The Chinese car owner reported that he is unable to provide more detailed information about the A5 camera retrofit, as the Lane Assist. was installed by a modification shop.
He also mentioned that after consulting with others in China who have experience with similar retrofits, so far no one has been able to make the instrument cluster display Lane Assist–related information.

Because they use my experience from D2 =))