Gearstick not centring back to neutral
-
kasialis721
- New
- Posts: 1
- Joined: Wed Nov 18, 2026 9:40 pm
- Drives: 2010 VW Polo S
- Location: London
Gearstick not centring back to neutral
Having an issue where the gearstick is not going back to neutral. It moves fine up and down (e.g. switching from 1st to 2nd, 3rd to 4th etc) but it does not centre moving side to side. I can't see any missing bushings or anything, I'll attach a picture of it, but I noticed the issue when I was trying to go into reverse: I was unable to get the stick into reverse, as I could not find the centre where neutral was meant to be. Happened all of a sudden, and happens both with the engine turned off and on. I think it could be an issue with that spring on the side, return spring?
- Attachments
-
- IMG_4644.jpeg (1.92 MiB) Viewed 507 times
-
- IMG_4645.jpeg (2.3 MiB) Viewed 507 times
-
- IMG_4643.jpeg (2.14 MiB) Viewed 507 times
- ciclo
- Bling Bling Diamond Member
- Posts: 9037
- Joined: Sun Feb 24, 2013 10:20 am
- Drives: 6R'13/G7.5'19
- Location: Earth ♥, Spain.
- Contact:
Re: Gearstick not centring back to neutral
Everything inside the cabin looks completely fine in your pictures, the return spring on the side is seated properly and not broken.
On a 2010 Polo, this issue is almost always located in the gearbox selector tower (under the bonnet, beneath the battery/airbox), specifically the horizontal pivot pin on the plastic/metal relay lever seizing up due to corrosion and dirt.
On a 2010 Polo, this issue is almost always located in the gearbox selector tower (under the bonnet, beneath the battery/airbox), specifically the horizontal pivot pin on the plastic/metal relay lever seizing up due to corrosion and dirt.
