Summary:
A8A000380E212023002000103C2B0C500000430F60060000300000000000
This was your coding and like you wrote i tested all possibilities with "(Bit3 and Bit5) and Byte7 (Bit4 and Bit5)"
i ended with 2 errors which reaturn after i lock & unlock car:
03303 - Response Closing Status of Rear Left Door
008 - Implausible Signal - Intermittent
03304 - Response Closing Status of Rear Right Door
008 - Implausible Signal - Intermittent
But doors are locking and unlocking, status in vcds is correct, no errors on speedo.
After diging in internet i found similar problem with Interior lights and find resolution

this wasn't connected with bcm upgrade. In transport part i have 2 lights, one is with led board, this with led board was set to react on door open. When switch it off interior lights works fine. The lamp has internal problem.
01044 - Control Module Incorrectly Coded <- this is lie

Has nothing to do with BCM, another idea from internet

I unplugged china radio and error don't return after deletion. I connected it back, active on Can Gateway installation list Radio & Navigation and i don't have this error but i have:
01304 - Radio
004 - No Signal/Communication - Intermittent
01300 - Control Module for Navigation with CD-Rom (J401)
004 - No Signal/Communication
So here there is no solution :/ I will have error in the can gateway regarding bad coding or errors with the radio and navi... another solution is radio replacement.
Next week i will replace battery
Thanks for help
